Skip to content
Clean Up/Spills - Fluorescent Bulbs
         

Cleaning Up a Broken Fluorescent Bulb

  Broken fluorescent bulb
Fluorescent light bulbs contain a small amount of mercury sealed within the glass tubing. This mercury does not pose a risk when the bulbs are used. When a fluorescent bulb breaks, some of this mercury is released as mercury vapor. The broken bulb can continue to release mercury vapor until it is cleaned up and removed. To minimize exposure to mercury vapor, it is recommended that you follow the clean-up and disposal steps outlined on this page.

Before Clean Up

  • Have people and pets leave the room and avoid the breakage area.
  • Open a window or door to the outdoors and leave the room for 5-10 minutes.
  • Shut off the central forced-air heating/air conditioning (H&AC) system.
  • Collect materials you will need to clean up the broken bulb:
    • Stiff paper or cardboard
    • Sticky tape (e.g., duct tape)
    • Damp paper towels or disposable wet wipes (for hard surfaces)
    • Glass jar with a metal lid (such as a canning jar) or a sealable plastic bag(s)

Clean-up Steps for Hard Surfaces

  • Carefully scoop up glass fragments and powder using stiff paper or cardboard and place debris and paper/cardboard in a glass jar with a metal lid. If a glass jar is not available, use a sealable plastic bag. (NOTE: Since a plastic bag will not prevent the mercury vapor from escaping, remove the plastic bag(s) from the home after cleanup.)
  • Use sticky tape, such as duct tape, to pick up any remaining small glass fragments and powder. Place the used tape in the glass jar or plastic bag.
  • Wipe the area clean with damp paper towels or disposable wet wipes. Place the towels in the glass jar or plastic bag.
  • Vacuuming of hard surfaces during clean up is not recommended unless broken glass remains after all other clean-up steps have been taken. [NOTE: It is possible that vacuuming could spread mercury-containing powder or mercury vapor.] If vacuuming is needed to ensure removal of all broken glass, keep the following tips in mind:
    • Keep a window or door to the outdoors open;  
    • Vacuum the area where the bulb was broken using the vacuum hose, if available; and 
    • Remove the vacuum bag (or empty and wipe the canister) and seal the bag/vacuum debris, as well as any materials used to clean the vacuum, in a plastic bag.
  • Promptly place all bulb debris and clean-up materials, including vacuum cleaner bags, outdoors in a trash container or protected area until materials can be disposed of properly. Contact your local solid waste director or recycling coordinator on how to properly dispose or recycle this material. Some communities offer ongoing collection programs for hazardous household materials while other local programs may hold single-day collection events. To identify your local recycling program contact, Visit www.scdhec.gov/environment/lwm/recycle/counties.htm or call the S.C. Department of Health and Environmental Control’s (DHEC) Office of Solid Waste Reduction and Recycling (Office) at 1-800-768-7348.
  • Wash your hands with soap and water after disposing of the jars or plastic bags containing bulb debris and cleanup materials.
  • Continue to air out the room where the bulb was broken and leave the H&AC system shut off, as practical, for several hours.

Clean-up Steps for Carpeting or Rugs

  • Carefully scoop up glass fragments and powder using stiff paper or cardboard and place debris and paper/cardboard in a glass jar with a metal lid. If a glass jar is not available, use a sealable plastic bag. (NOTE: Since a plastic bag will not prevent the mercury vapor from escaping, remove the plastic bag(s) from the home after cleanup.)
  • Use sticky tape, such as duct tape, to pick up any remaining small glass fragments and powder. Place the used tape in the glass jar or plastic bag.
  • Vacuuming of carpeting or rugs during clean up is not recommended unless broken glass remains after all other clean-up steps have been taken. [NOTE: It is possible that vacuuming could spread mercury-containing powder or mercury vapor.] If vacuuming is needed to ensure removal of all broken glass, keep the following tips in mind:
    • Keep a window or door to the outdoors open;
    • Vacuum the area where the bulb was broken using the vacuum hose, if available, and 
    • Remove the vacuum bag (or empty and wipe the canister) and seal the bag/vacuum debris, and any materials used to clean the vacuum, in a plastic bag.
  • Promptly place all bulb debris and clean-up materials, including vacuum cleaner bags, outdoors in a trash container or protected area until materials can be disposed of properly. Contact your local solid waste director or recycling coordinator for proper disposal or recycling options.
  • Wash your hands with soap and water after disposing of the jars or plastic bags containing bulb debris and cleanup materials.
  • Continue to air out the room where the bulb was broken and leave the H&AC system shut off, as practical, for several hours.

Future Cleaning of Carpeting and Rugs: Air Out the Room During and After Vacuuming

  • The next several times you vacuum the rug or carpet, shut off the H&AC system if you have one, close the doors to other rooms, and open a window or door to the outside before vacuuming. Change the vacuum bag after each use in this area.
  • After vacuuming is completed, keep the H&AC system shut off and the window or door to the outside open, as practical, for several hours.  
The U.S. Environmental Protection Agency (EPA) is the source for the information on this page.

 



Home About Mercury CleanIng Up Spills Fish FAQs
Fluorescent Bulbs Mercury in SC Mercury Reduction Thermostats U.S. EPA